Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Figure 7
Figure 8
Figure 10
Machine Set-up
How to Install the Dust Control Skirt
To install the skirt, follow this procedure:
1.
Wrap the skirt around the bumper such that the draw string can be
inserted into the recess of the bumper. See figure 7.
2.
Orient the brush fastening strap at the rear of the machine to prevent
scratching surfaces.
3.
Tighten and tie the string on the skirt into a bow knot so it can later
be untied for removal of the skirt.
4.
Twist the ends of the string (see figure 7) and insert them into the
recess of the bumper as shown in figure 8.
NOTE: The skirt should be stored flat on the floor either on or off
of the machine.
Operating Instructions
.
The switch to start and stop the machine is activated by the interlock
switch (Fig. 10) and the levers (Fig 10A) under the handle grips.
10
DANGER:
Machine can have high starting torque. Do
not operate machine on rough or uneven
surfaces. Do not operate on a slope. It is
possible for the machine to move suddenly
from side to side and even leave the ground if
misused during operation. Only experienced
operators should use machine for
applications that impart high torque on the
machine. If unable to control the machine
during operation, release the handle and step
away from the machine. It will stop
automatically.
WARNING:
Never start machine when the handle is
in the vertical position.
Publicidad
