Doosan DCT25BV Operación Y Mantenimiento página 16

EN
Look for these signs on machines shipped to markets in North America, which point out potential hazards to the
safety of you and others. Read and understand thoroughly. Take notice of warnings and follow instructions.
If you do not understand, inform your supervisor.
DAN G E R
Red Background
Indicates the presence of a hazard which WILL cause
serious injury, death or property damage, if ignored.
WA R N IN G
Yellow Background
Indicates the presence of a hazard which WILL or can cause
injury or property damage, if ignored.
DCT25BV and DCT25BS Paving Breakers are designed for the disintegration of low to medium strength materials
(e. g. concrete, masonry bituminous asphalt etc). The tool is intended for vertical or inclined down ward breaking.
Doosan Benelux SA is not responsible for customer modifications of tools for applications on which Doosan
Benelux SA was not consulted.
IT IS THE RESPONSIBILITY OF THE EMPLOYER TO PLACE THE INFORMATION
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
PLACING TOOL IN SERVICE
• Always operate, inspect and maintain this tool in
accordance with all regulations (local, state, federal and
country), that may apply to hand held/hand operated
pneumatic tools.
• For safety, top performance, and maximum durability
of parts, operate this tool at 103 psig (7.0 bar/700 kPa)
maximum air pressure at the inlet with 3/4" (19 mm) inside
diameter air supply hose.
• Always turn off the air supply and disconnect the air
supply hose before installing, removing or adjusting
any accessory on this tool, or before performing any
maintenance on this tool.
• Do not use damaged, frayed or deteriorated air hoses and
fittings.
• Be sure all hoses and fittings are the correct size and
are tightly secured. See Dwg. PP1 for a typical piping
arrangement.
• Always use clean, dry lubricated air at 103 psig
(7.0 bar/700 kPa) maximum air pressure. Dust, corrosive
fumes and/or excessive moisture can ruin the internal
components of an air tool.
• Do not lubricate tools with flammable or volatile liquids
such as kerosene, diesel or jet fuel.
• Do not remove any labels. Replace any damaged labels.
The use of other than genuine Doosan Benelux SA replacement parts may result in safety hazards, decreased tool
performance, and increased maintenance, and may invalidate all warranties.
Repairs should be made only by authorised trained personnel. Consult your nearest Doosan Benelux SA Authorised
Servicenter.
N OTI CE
WA RNIN G
IMPORTANT SAFETY INFORMATION ENCLOSED.
READ THIS MANUAL BEFORE OPERATING TOOL.
IN THIS MANUAL INTO THE HANDS OF THE OPERATOR.
N OTI CE
CAUTIO N
Orange Background
Indicates the presence of a hazard which CAN cause
serious injury, death or property damage, if ignored.
N OT ICE
Blue Background
Indicates important set-up, operating or maintenance
information.
USING THE TOOL
• Always wear eye protection when operating or performing
maintenance on this tool.
• Always wear hearing protection when operating this tool.
• Keep hands, loose clothing and long hair away from
rotating end of tool.
• Anticipate and be alert for sudden changes in motion
during start up and operation of any power tool.
• Keep body stance balanced and firm.
Do not overreach when operating this tool.
• Tool accessories may continue to impact briefly after
throttle is released.
• Air powered tools can vibrate in use. Vibration, repetitive
motions or uncomfortable positions may be harmful to
your hands and arms. Stop using any tool if discomfort,
tingling feeling or pain occurs.
Seek medical advice before resuming use.
• Use accessories recommended by Doosan Infracore
Portable Power.
• This tool is not designed for working in explosive
atmospheres.
• This tool is not insulated against electric shock.
16