Publicidad
Idiomas disponibles
Idiomas disponibles
20. Screw U-support tube (#21) to Strut Tubes (#17) with two Screws
(#5) as shown in Figure 11. Align holes in U-support with holes
in Strut Tubes and thread screw (#5) into hole in Strut Tube
(#17). Tighten screws all the way but be careful not to over
tighten as you could strip threads on screws.
Note:
If hinge (#18) is positioned as shown in Detail K, you will have to rotate the
hinge to the position shown in Detail L. DO NOT unscrew the hinge, you can rotate
the hinge without unscrewing it from the table.
If you want to see a video on how to position Hinge (#18) go to:
http://www.escaladesports.com/customer-service/videos.html
21. Attach Hinges (#18) to Strut Tubes (#17) as shown in Figure
11 & Detail L. With hinge positioned as shown, align hole in
hinge with hole in Strut Tube and attach with ¼" Screw (#30),
Plastic Washer (#38) and Locknut (#34). Plastic Washer (#38)
goes between Strut Tube and Hinge. Tighten nut securely. Repeat
for other Hinge. CAUTION: Hinges must be positioned
exactly as shown or table will not operate correctly and
could be damaged. DO NOT take Hinges off.
DO NOT OPEN THE TABLE TO PLAYING POSITION UNTIL
BOTH TOPS ARE INSTALLED! DO NOT LEAVE TABLE
STANDING UNATTENDED. IT COULD BE KNOCKED OVER
CAUSING SERIOUS BODILY INJURY OR PROPERTY DAMAGE.
ATTENTION: If hinge is positioned as
shown below (Detail K), Rotate the hinge
as shown in Detail L. Do not take hinge off.
18
Detail K
Incorrect position
of hinge
CAUTION: Position hinges exactly as
shown in Detail L or table will not
operate correctly and could be damaged.
Detail L
30
18
Correct position
of hinge
In the correct position
Hinge #18 will look like a
"V" when attached to Strut
Tube (#17).
16
17
29
34
38
16
17
30
18
Hinge Assembly
22. Attach Linkages (#16) to Leg (#19) as shown in
Figure 11. Pivot Leg (#19) out from the table top
and pivot both linkages (#16) up and align hole in
Linkage with hole in Leg (#19). Attach Linkage
(#16) to Leg (#19) using Hex Head Bolt (#29),
Spacer (#37) and Locknut (#34). Spacer (#37)
goes between Linkage and Leg. Attach other
Linkage to Leg the same way. Tighten nuts securely.
23. Attach Corner Protector (#40) to table corners.
Push snap tabs on Corner Protector into holes in
rails. Be sure that tabs are aligned with holes
before pushing. You could break tabs if they are
not aligned correctly.
24. With at least two adults, repeat steps 19
.
through 23 for other table top assembly.
Figure 11
34
34
37
21
5
17
17
34
38
Hinge Assembly
11
40
19
29
Spacer goes between
Linkage Arm (#16) and
Leg (#19)
16
5
30
38
Plastic Washer goes
between Strut Tube
(#17) and Hinge (#18)
18
37
Publicidad
