Descargar Imprimir esta página

Samsung NX58942 Serie Manual Del Usuario página 42

Publicidad

Idiomas disponibles

Idiomas disponibles

Troubleshooting
Problem
Very large or
The wrong burner orifice
yellow surface
is installed.
burner flames.
Surface burners
The oven door lock is
light but oven
turned on.
burners do not
light.
The Gas Pressure
Regulator shut off switch
is in the off position.
Oven
Problem
The oven control
There may be an issue
beeps and displays
with your oven. See the
an information
"Information codes" chart
code.
on page 46.
42 English
NX58M9420S_DG68-00905A-07_EN+MES+CFR.indb 42
Cause
Action
Check the burner orifice size.
Contact your installer if you
have the wrong orifice (LP
gas instead of natural gas or
natural gas instead of LP gas).
The display will show the Lock
icon. Hold the oven door open
and press the START/SET pad
for 3 seconds. The oven will
beep and the Lock icon will
turn off.
Call a qualified service
technician.
Cause
Action
Press the OFF/CLEAR pad, and
then restart the oven.
If the problem persists,
disconnect all power to the
range for at least 30 seconds
and then reconnect the power.
If this does not solve the
problem, call for service.
Problem
Cause
The oven will not
The oven is not
turn on.
completely plugged into
the electrical outlet.
A fuse in your home
may be blown or the
circuit breaker may have
tripped.
The oven
The oven temperature
temperature is too
needs to be adjusted and
hot or cold.
recalibrated.
The oven burner
The oven door lock is
will not shut off.
turned on.
The Sabbath function has
been activated.
Action
Make sure the electrical plug
is fully inserted into a live,
properly grounded outlet.
Replace the fuse or reset the
circuit breaker.
See page 30.
The display will show the Lock
icon. Hold the oven door open
and press the START/SET pad
for 3 seconds. The oven will
beep and the Lock icon will
turn off.
SAb and the time of day will
show in the display. All other
controls and signals will be
deactivated. To turn off the
oven only, press the OFF/
CLEAR pad.
To cancel the Sabbath function
and reactivate the controls
and signals, press and hold
the Bake and NUM 1 pads
simultaneously for 3 seconds.
2019-02-28
12:18:11

Publicidad

loading