Kodak ABR2300 Manual Del Operador página 16

REPLACING THE LENS
14
To install a Lens with a magnification different from that already installed in the machine, follow the
procedure given below.
Take hold of the Prism Holder Lever and pull it up
to raise the Prism Holder.
Pull out the Lens Unit.
Slide the Lens Unit into the machine along the
Lens Guide.
Pull out the Brightness Select Lever and slide it to
the position corresponding to the type of
Projection Lens being used.
NOTE
Brightness on the Screen is uneven if the
Brightness Select Lever is not placed in a
position corresponding to the type of
Projection Lens being used. Be sure to
place the Lever in the correct position
according to the type of Projection Lens.