Domo DO939K Manual De Instrucciones página 39

Internal temperature not cold enough
· Check connection of power cord to power source.
· Plug in unit.
· Check setting and adjust as needed.
· Close door securely.
· Be sure that food is cool before inserting.
· Do not keep door open for too long and minimize door openings.
· Allow room for air to circulate around unit.
· Use proper voltage.
· Do not place unit close to heat sources or direct sunlight.
CLEANING AND MAINTENANCE
· Do not use abrasive cleaning agents or solvents.
· Set the temperature control knob to the 0 position and disconnect the mains plug from the
mains socket.
· Take out the food and store in a cool location.
· Clean the appliance with a soft cloth, warm water and detergent.
· Wipe the door seal with clear water only and then wipe dry thoroughly.
· After cleaning reconnect and adjust the temperature control knob as desired.
· Put the food back into the appliance.
DEFROSTING THE FRIDGE
The refrigerator defrosts fully automatically. While the
cooling is running, beads of condensation or hoarfrost
form at the back of the refrigerator. This is normal. It is not
necessary to wipe off the condensation or frost. The rear
panel defrosts automatically. The condensation runs into
the condensation channel and is conveyed to the cooling
from where it evaporates.
Note: Keep the condensation channel and drainage hole
clean, so that the condensation can run out.
DEFROSTING
A layer of frost in the freezer will impair refrigeration of the frozen food and increases power
consumption. Remove the layer of frost regularly. Do not scrape off frost or ice with a knife or
pointed object. Doing this may damage the refrigerant tubes.
1. Remove the frozen food and place temporarily in a cool location.
2. Disconnect the appliance from the mains socket.
www.domo-elektro.be
39
DO939K