Publicidad
1.6.2 Front Panel Switches & Indicators Headers
This header is used for connecting switches and
LED indicators on the chassis front panel.
Watch the power LED pin position and orientation.
The mark "+" align to the pin in the figure below
stands for positive polarity for the LED connection.
Please pay attention when connecting these
headers. A wrong orientation will only result in the
LED not lighting, but a wrong connection of the
switches could cause system malfunction.
•
HLED (Pin 1, 3):
Connects to the HDD LED cable of chassis
front panel.
•
RST (Pin 5, 7):
Connects to the Reset Switch cable of chassis
front panel.
•
SPKR (Pin 13, 15, 17, 19):
Connects to the System Speaker cable of
chassis.
•
SLED (Pin 2, 4):
Connects to the Suspend LED cable (if there
is one) of chassis front panel.
•
PWR (Pin 6, 8):
Connects to the Power Switch cable of chassis front panel.
•
PLED (Pin 16, 18, 20):
Connects to the Power LED cable of chassis front panel.
1.6.3 FAN Power Connectors
These connectors each provide power to the
cooling fans installed in your system.
•
CPUFAN1: CPU Fan Power Connector
•
SYSFAN1: System Fan Power
Connector
•
AUXFAN1~2: Auxiliary Fan Power
Connector
These fan connectors are not
※
jumpers. DO NOT place jumper
caps on these connectors.
F-I90HD
Get user manuals:
See SafeManuals.com
.
1-7
Publicidad
