IPC Sync DS 2009M Manual De Instrucciones página 24

TABLE OF ROUTINE MAINTENANCE TO BE PER-
FORMED BY THE USER.
Description of operations:
Check power cable - pipes - high pressure
connectors.
Ist oil change in H.P. pump.
Subsequent changes in H.P. pump.
Change and clean fuel filters.
Clean fuel tank.
Clean water filter.
These intervals refer to normal working conditions. For heavy duty use decrease the interval for each job.
For maintenance and/or repairs, use only original spare parts which offer the greatest characteristics of quality and
reliability. Failure to use original spare parts absolves the manufacturer from all liability and transfers it to the
If the machine is to remain inactive for a long period, disconnect the supply sources, drain the tank(s) of all the operating fluids
and protect any parts that could be damaged by the accumulation of dust.
Grease the parts that could be damaged by drying out, such as the supply hoses. When bringing back into use, ensure that
there are no cracks or cuts in the water supply hoses.
Oil and chemical products must be disposed of according to current legislation.
If you decide that the cleaner is no longer to be used, render it inoperative by removing the electric power cable. Ensure that all
parts of the cleaner that could be a source of danger are made harmless, especially for children who might use the old cleaner
for play. As the cleaner is considered special waste, dismantle it and divide the material according to type, then dispose of them
as required by the legislation in force.
Do not use parts dismantled for scrap as spare parts.
English
TABLE OF EXTRAORDINARY MAINTENANCE TO
BE PERFORMED BY THE TECHNICAL SERVICE
CENTRE.
Description of operations:
Boiler:
Clean Coil.
Each use
Descale coil.
Clean fuel pump.
Change fuel nozzle.
After 50 hours
Regulade electrodes.
Every 500 hours
Change electrodes.
Every 100 hours
Change seals on H.P. pump.
Every 100 hours
Change lanze nozzle.
Every 50 hours
Calibrate and check the safety devices.
IMPORTANT:
person carrying out the operation.
PERIODS OF INACTIVITY
SCRAPPING
- 24 -
Every 200 hours
Every 300 hours
Every 200 hours
Every 200 hours
Every 200 hours
Every 500 hours
Every 500 hours
Every 200 hours
Once a year