Publicidad
Idiomas disponibles
Idiomas disponibles
CONNECT THE WIRING
GROUND
SCREW
Connect House Power Cable to range hood wiring -
22
BLACK to BLACK, WHITE to WHITE, and GREEN or
BARE WIRE to Ground Screw.
23
Replace wiring cover.
24
Re-connect lamp wire harness and re-attach bottom panel
with (8) screws as shown in Step 9.
INSTALL LIGHT BULBS
HALOGEN
BULB
(2)
ROTATE
CLOCKWISE
CAUTION: Bulbs may be hot. Always allow bulbs
to cool before removing them.
Install (2) Halogen Bulbs. Use 120 V, 35 W, shielded
25
halogen bulbs - MR16 with GU10 base.
NOTE: Suction Cup Tool (included with hood) can be
used to install and remove light bulbs.
Align pins on bulb with large diameter opening on socket,
then push bulb up into socket and rotate clockwise until
firmly seated.
The position of the bulb socket (depth) is adjustable and
may require adjustment when:
a) certain brands of bulbs are difficult to install.
b) the bulb protrudes too far below the light panel.
HOUSE
POWER CABLE
SUCTION
CUP TOOL
(1)
PUSH IN
LIGHT PANEL
LAMP SOCKET
BRACKET
To change the depth of bulb sockets:
- Remove bottom panel (See Step 9).
- Disconnect light harness.
- Loosen 2 Screws holding Lamp Socket Bracket to
Light Panel.
- Adjust socket/bracket to desired depth.
- Re-tighten screws securely.
- Re-attach light harness and replace bottom panel.
26
DUCTED INSTALLATION ONLY:
Re-install aluminum filters removed in Step 8.
NON-DUCTED INSTALLATION ONLY:
Purchase a non-ducted filter (Model BPQTF) from your
local distributor or retailer. Attach the non-ducted filter fol-
lowing instructions packed with the non-ducted filter.
CBD3 SERIES
Page 6
SCREWS
Publicidad
