Home Decorators Collection 34545-HBUN Manual De Instrucciones página 10

Assembly - Standard Ceiling Mount (continued)
7
Mounting the fan
WARNING: When using the standard ball/downrod mounting, the
tab in the ring at the bottom of the mounting bracket must rest in
the groove of the hanger ball. Failure to properly seat the tab in
the groove could cause damage to the wiring.
□
Align the locking slots of the ceiling canopy (C) with the two
canopy screws (AA) in the mounting bracket (B). Push up to r
engage the slots and turn clockwise to lock in place.
□
Firmly tighten the two canopy screws (AA).
□
Install the two canopy screws (AA) (saved from Assembly
Step 1 "Preparing for mounting") into the holes in the
canopy (C) and tighten firmly.
AA
B
C
9
Installing the light bulbs and
glass bowl
□ With the power off, install the two LED bulbs (I)
(Max. 5W provided) into the light bulb sockets.
□ Place the glass bowl (H) into the light kit pan, aligning
the three flat areas on the top flange of the glass bowl
(H) with the three raised dimples in the light kit pan.
Turn the glass bowl (H) clockwise until it stops.
8
□ Remove and save the set screws (2) on the decorative sheet.
□ Remove the decorative sheet from the top motor housing.
□ Attach the fan blades (A) to the fan motor assembly (G)
□ Repeat these steps for the remaining blades (A).
□ Reattach the decorative sheet on top motor housing, line up
AA
E
F
G
10
Attaching the fan blades
by using the blade screws (BB) and fiber washers (CC).
Tighten blade screws (BB) securely.
the 2 holes, insert the screws and tighten.
BB
CC
A
G
I
H