Publicidad
Idiomas disponibles
Idiomas disponibles
36
MAINtENANcE
CHANGING THE OVEN LIGHT
The oven light is a standard 25-watt halogen bulb for
ovens.
Replacing Lamp on Side Wall
• Make sure oven and bulb are cool.
1. Unplug oven or disconnect power.
2. Remove oven racks.
3. Slide a flat blade screwdriver between the housing
and the glass light cover.
4. Support the glass light cover with two fingers to
prevent the cover from falling to the bottom of
the oven.
5. Gently twist the screwdriver blade to loosen the
glass light cover.
6. Remove bulb from socket.
7. Replace bulb, replace light cover by snapping
back into place.
8. Plug in oven or reconnect power.
Glass Light Cover
Flat blade screwdriver
WARNING
• Before replacing the oven light bulb,
DISCONNECT the electrical power to the oven
at the main fuse or circuit breaker panel.
− Failure to do so can result in severe personal
injury, death, or electrical shock.
• Make sure oven and bulb are cool.
• Wear gloves while changing the oven light.
Glass fragments from broken bulbs can cause risk
of injury.
CLEANING THE EXTERIOR
Painted Parts and Trim
For general cleaning, use a cloth with hot and soapy
water. For more difficult soils and built-up grease, apply a
liquid detergent directly onto the soil. Leave on soil for 30
to 60 minutes. Rinse with a damp cloth and dry. DO NOT
use abrasive cleaners on any of these materials; they can
scratch the parts and trim.
Stainless Steel Surfaces
Do not use a steel-wool pad, it will scratch the surface.
1. Place a small amount of Stainless Steel Appliance
Cleaner or polish on a damp cloth or damp paper
towel.
2. Clean a small area, rubbing with the grain of the
stainless steel if applicable.
3. Dry and buff with a clean, dry paper towel or soft
cloth.
4. Repeat as necessary.
Housing
If a mineral oil-based stainless steel appliance
cleaner has been used before to clean the appliance,
wash the surface with a mild soap and water prior to
using the Stainless Steel Appliance Cleaner or polish.
NOTE
Publicidad
