DeWalt D25810 Manual De Instrucciones página 7

2. Turn the bit slightly until the sleeve snaps back into
position.
3. Ensure the bit is properly engaged.
nOTE: The bit needs to move several centimeters in and
out of the bit holder 7 when properly engaged.
Fig. C
7
To remove the bit, pull back the locking sleeve and pull the
bit out.
Bit Position Adjustment
Turn the mode selector to bit adjustment icon (Refer to
Mode Selection) to adjust the chisel to the desired position.
There are multiple positions to set the angle of the chisel.
nOTE: After finding the desired position, slightly maneuver
the chisel bit back and forth to ensure the chisel is
properly engaged.
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Proper Hand Position (Fig. D)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the mounted
side handle, with the other hand on the main handle.
Fig. D
SHOCKS Active Vibration Control®
System
For best vibration control, hold the tool as described in
Proper Hand Position and apply just enough pressure so
the damping device on the main handle is approximately
mid stroke. The hammer only needs enough pressure to
engage the active vibration control. Applying too much
pressure will not make the tool chip faster and active
vibration control will not engage.
8
Mode Selection (Fig. E)

WARNING: Do not select the operating mode when
the tool is running. Tool must come to a complete stop
before activating the mode selector button or damage
to the tool may result.
Your tool is equipped with a mode selector dial
select the mode appropriate to desired operation.
symbol Mode
Bit Adjustment
hammering/
Chipping
To select a mode:
1. Depress the mode selector release button
2. Rotate the mode selector dial so that the arrow points to
the symbol corresponding for the desired mode.
Fig. E
5
nOTE: The arrow on the mode selector dial
pointing at a mode symbol at all times. There are no
operable positions in between.
Performing an Application (Fig. A, F)

WARNING: TO REDUCE THE RISK OF PERSONAL
INJURY, ALWAYS ensure workpiece is anchored or
clamped firmly.
nOTE: Operating temperature of this tool is 19˚ to 104˚ F
(-7 to +40˚ C). Using the tool outside of this temperature
range will decrease the life of the tool.
1. Insert the appropriate chisel and rotate it by hand to
lock it into the desired position.. Refer to Bit and Bit
Holder.
2. Using the mode selector dial
Refer to Mode Selection.
3. Adjust the side handle 2
Fig. F
4
2
4. Place the bit/chisel on the desired location.
English
4 to
Application
Chisel bit position
adjustment
Light chipping, chiseling
and demolition
5 .
4
must be
6
4 , select chipping mode .
as necessary.
1
5