Pioneer SUPER TUNER III D DEH-P4800MP Manual De Instrucciones página 34

Section
08 Audio Adjustments
3 Press c or d to select the desired fre-
quency.
Press c or d until the desired frequency ap-
pears in the display.
Low: 4080100160 (Hz)
Mid: 2005001k2k (Hz)
High: 3k8k10k12k (Hz)
4 Press a or b to select the desired Q fac-
tor.
Press a or b until the desired Q factor ap-
pears in the display.
2N1N1W2W
Note
If you make adjustments, CUSTOM curve is up-
dated.
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Press AUDIO to select LOUD.
Press AUDIO until LOUD appears in the dis-
play.
2 Press a to turn loudness on.
Loudness level (e.g., LOUD :MID) appears in
the display.
3 Press c or d to select a desired level.
Each press of c or d selects level in the fol-
lowing order:
LOW (low)MID (mid)HI (high)
4 Press b to turn loudness off.
LOUD :OFF appears in the display.
Using subwoofer output
This unit is equipped with a subwoofer output
which can be turned on or off.
34
En
All manuals and user guides at all-guides.com
1 Press SW to select SUB W.
SUB W appears in the display.
# You can also select the subwoofer setting
menu by pressing AUDIO on the unit.
# When the subwoofer controller setting is
P/O :FUL, you cannot select SUB W.
2 Press a to turn subwoofer output on.
SUB W:NOR appears in the display. Subwoo-
fer output is now on.
# If the subwoofer output phase has been set to
the reverse, SUB W:REV will be displayed.
# To turn subwoofer output off, press b.
3 Press c or d to select the phase of sub-
woofer output.
Press c to select reverse phase and REV ap-
pears in the display. Press d to select normal
phase and NOR appears in the display.
Adjusting subwoofer settings
When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
1 Press SW to select 80: 0.
Press SW until 80: 0 appears in the display.
# You can also select the subwoofer setting
menu by pressing AUDIO on the unit.
# When the subwoofer output is on, you can se-
lect 80: 0.
# If the subwoofer setting has been previously
adjusted, the frequency of that previously se-
lected will be displayed instead of 80.
2 Press c or d to select cut-off frequency.
Each press of c or d selects cut-off frequen-
cies in the following order:
506380100125 (Hz)
Only frequencies lower than those in the se-
lected range are outputted from the subwoo-
fer.