NV51R5511S_AA_DG68-01125A-02_EN+MES+CFR.indb 33
4.
Lower the oven door to the fully open
position. If the oven door does not open
to a full 90°, repeat steps 1 through 3.
5.
Locate the oven door hinge locks in the
corners of the oven door, and rotate the
hinge locks toward the oven cavity to
the locked position.
See Step 3 (illustration A) in the
"Removing the oven doors" section for
the proper locked position.
6.
Close the oven door.
7.
When the hinges are properly installed
and the door is closed, there should be
an even gap between the door and the
control panel. If one side of the oven
door is hanging lower than the other,
the hinge on that side is not properly
installed.
Changing the oven light
The oven light is a standard 40-watt appliance halogen bulb. It comes on when the
oven door is open. When the oven door is closed, touch
or off. It will not work during a self-cleaning cycle.
CAUTION
Before changing the oven light, make sure to wear gloves to protect your hands.
1.
The broil heater is not a removable part. Do
not force the broil heater down. Do not let it
drop down.
to turn the light on
To change the bulb, you must tilt
the broil heater down. To do this,
turn the circular nut on the support
counterclockwise while holding the
broil heater. The broil heater should
loosen and tilt down.
CAUTION
English 33
11/5/2019 10:24:35 AM