Safety Notes; Conformity And Approval - IMG STAGELINE WSA-24R Manual De Instrucciones

AC 9 V~ 500 mA 50/60 Hz
1
Audio Signal Transmission System
These instructions are intended for users
without any specific technical knowledge.
Please read the instructions carefully prior to
operation and keep them for later reference.
1 Applications
In combination with one or multiple receiv-
ers WSA-24R, the transmitter WSA-24T pro-
vides a wireless system for audio signal trans-
mission (e. g. music reproduction in different
parts of a building). The transmission range
depends on local conditions and may reach
30 m as a maximum.

2 Safety Notes

The units (transmitter, receiver, power supply
units) correspond to all relevant directives of
the EU and are therefore marked with
WARNING The power supply units use
dangerous
Leave servicing to skilled per-
sonnel only. Inexpert handling
may result in electric shock.
•
The units are suitable for indoor use only.
Protect them against dripping water and
splash water, high air humidity and heat
(admissible ambient temperature: 0 – 40 °C).
•
Immediately disconnect the power supply
unit from the mains socket
1. if the power supply unit or the transmit-
ter/receiver is visibly damaged,
2. if a defect might have occurred after the
unit was dropped or suffered a similar
accident,
3. if malfunctions occur.
In any case the units must be repaired by
skilled personnel.
•
For cleaning only use a dry, soft cloth;
never use water or chemicals.
•
No guarantee claims for the units and no
6
ANT
2 3
mains voltage.
Receiver
WSA-24R
liability for any resulting personal damage
or material damage will be accepted if the
units are used for other purposes than
originally intended, if they are not correct-
ly connected or operated, or if they are not
repaired in an expert way.
If the units are to be put out of op-
eration definitively, take them to a
local recycling plant for a disposal
which is not harmful to the envi-
ronment.

2.1 Conformity and approval

Herewith, MONACOR INTERNATIONAL de-
clare that the audio signal transmission sys-
tem (WSA-24R and WSA-24T) complies with
the directive 2014 / 53 / EU. The EU declarations
of conformity are available on the Internet:
.
www.img-stageline.com
The units are generally approved for oper-
ation in EU and EFTA countries; they are li-
cence-free and require no registration.
3 Setting the System into Operation
1) Find a suitable position for the receiver
(or multiple receivers) WSA-24R, then set
the receiver up, screw it on or attach its
holding magnets to a magnetic surface.
Put the antenna (3) in a vertical position.
2) Use an audio cable to connect the 6.3 mm
jacks OUTPUT (4) to the input (e. g. LINE,
CD, AUX) of the subsequent unit (e. g. am-
plifier, mixer, active speaker system).
3) Connect the power supply unit provided
to the jack AC 9 V~ (2) and to a mains sock-
et (230 V/ 50 Hz). The button PAIR (5) starts
flashing.
The receiver is provided with a hook
for strain relief (1): Lead the cable around
the hook to prevent accidental disconnec-
tion of the power supply unit from the
receiver.
PAIR
BAL
UNBAL
OUTPUT
LEFT RIGHT
4 5