Publicidad
Idiomas disponibles
Idiomas disponibles
Operating Instructions
Operating Instructions
(Continued)
LOADING/UNLOADING THE TOOL
1. Always disconnect
the tool from the air
supply before loading
fasteners.
2. Push
down on
the latch
button.
Pull back
on the
magazine
cover.
3. Load a clip of staples
with the crowns
straddling the
magazine rail.
4. Push the magazine
cover forward
until latch button
pops up.
5. Always unload all fasteners before
removing tool from service.
Unloading is the reverse of loading,
except that you must disconnect the
air supply before unloading.
ADJUSTING THE FASTENER
PENETRATION
The tool is equipped with an adjustable
depth of drive feature. This allows the
user to determine how deep a fastener
will be driven into the work surface.
1. Adjust operating pressure so nails
are driven consistently. Do not
exceed 100 psi.
2. To drive
the nail
shallower,
turn the
(C)
wheel (C)
to right to
the extent
desired.
3. To sink a nail
deeper, turn
the wheel
(C) to left to
the extent
desired.
4. Make sure trigger and work contact
element (WCE) move freely up and
down without binding or sticking
after each adjustment.
www.chpower.com
ADJUSTING THE DIRECTION OF THE
EXHAUST
The tool is equipped
with an adjustable
direction exhaust
deflector. This is
intended to allow
the user to change
Latch
the direction of the exhaust. Simply
Button
twist the deflector to any direction
desired.
User - Maintenance
Instructions
CLEARING A JAM FROM THE TOOL
1. Disconnect the air
supply from the tool.
2. Remove all fasteners
Magazine Rail
from the magazine
(see Loading/
Unloading). Failure to
do so will cause the
nails to eject from the front of the
tool.
3. Loosen cap screws on nose of tool.
Slide nose downward and remove
from tool to expose jammed
fastener.
4. Reinstall nose assembly in reverse
order in Step #3.
5. Make sure the trigger and Work
Contact Element (WCE) move freely
up and down without sticking or
binding.
TECHNICAL SERVICE
Please call our Tool Hotline at 1-800-
543-6400 with any questions regarding
the operation or repair of this tool or
for additional copies of this manual.
FASTENER AND REPLACEMENT
Rotate
PARTS
18 gauge fasteners (or equivalent - see
Fastener Interchange Information).
Tool performance, safety and durability
could be reduced if improper fasteners
are used. When ordering replacement
parts or fasteners, specify by part
number.
TOOL REPAIR
Only qualified personnel should repair
the tool and they should use genuine
Campbell Hausfeld replacement parts
and accessories, or parts and accessories
which perform equivalently.
ASSEMBLY PROCEDURE FOR SEALS
When repairing a tool, the internal
parts must be cleaned and lubricated.
Parker O-lube or equivalent must be
used on all o-rings. Each o-ring must be
coated with O-lube before assembling.
A small amount of oil must be used on
all moving surfaces and pivots. After
reassembling, a few drops of 30W
non-detergent oil or equivalent, must
be added through the air line before
testing.
STORAGE
The tool should be stored in a cool dry
place.
6
SN338K00
Use only genuine
Campbell Hausfeld
Publicidad
