Publicidad
Idiomas disponibles
Idiomas disponibles
The Connection of Loudspeaker
• The device can be adopted the loudspeaker with load impedance of 4-8. Before connecting a loudspe-
aker, please cut off the power to avoid any short.;
• Note: Do not contact the loudspeaker cable with the car's ground wire; especially, avoid any contact
between the loudspeaker cable and power cable; otherwise, the loudspeaker will be damaged seriously.
The Installation of Host Machine
• Insert the aerial plug into the antenna pedestal (adjust the antenna for a good effect);
Disassembly:
• Remove the panel's frames and then insert two brackets into the hole until they are locked; then pull the
machine out (See Drawing III, IV and V).
Replacement of Fuse
Pull out the invalid fuse and insert a new fuse with the same specification into the blank socket.
Explanation for Common Faults
16
During using the player, common faults can be solved as the following table. If any unmentioned fault is
found, please contact with the nearby franchiser immediately.
Solutions of Problems
Lack of Power Supply
The car is not ignited/ if any power supply has been installed in the car's accessory, you can turn the igni-
tion switch to ACC/ if the fuse has broken, you can replace a new fuse/ the player cannot work normally/ if
the temperature in the car is too high, you can enable the temperature to be normal and then try again.
Soundless:
If the volume is set as the minimum, you can adjust it to a proper level. Improper wiring, unsuitable or
broken format of memorizer's (SD/USB) file may cause the soundless effect.
Failure of Reception of a Radio
If the antenna is not connected well or the signal is too weak, you can insert the antenna into the antenna
hole firmly; if the searched broadcasting station cannot be locked in the automatic search, the station's
signal may be too weak, you can select the station manually; besides, if you start AMS mode, you'll obtain
a better effect.
www.multilaser.com.br
Publicidad
