Operate The Appliance; Using For The First Time; Switching The Appliance Off - NUK 10.749.057 Manual De Instrucciones

Luftbefeuchter 1108 Seite 8 Mittwoch, 25. Februar 2009 10:21 10
1. To start the instrument, open the battery
compartment and remove the safety strip
from the battery.
The instrument is now operational and
displays humidity and temperature.
2. To switch the temperature display from
"°C" to "°F", press the button in the rear of
the instrument using a thin and spiky object
(such as a toothpick).

6.1 Using for the First Time

Warning!
To protect you against electric shock
always disconnect the mains plug
before filling the water tank.
1. Take water tank 3 off base of the appliance
9 (Figure 1).
2. Turn over water tank 3 and unscrew the
sealing cap (Figure 2).
Warning!
To prevent limescale deposits and
growth of bacteria hazardous to
health:
• it is essential to use fresh and clean,
ideally boiled or distilled water every
time you use the appliance.
• the water temperature should not
exceed 20°C.
• never use additives such as substances
for inhalation or essential oils.
3. Fill water tank 3 with up to 2l of water as
required (Figure 3).
4. Screw sealing cap tightly onto water tank 3
(Figure 4).
5. Put water tank 3 back on base of the
appliance 9 (Figure 5).
3. Now check the humidity in your baby's
Important: As soon as the display becomes
unclear, replace the battery with a new one,
type AG13 1.5V.
Important: Recommended room temperature
is about 16-20°C, recommended relative
humidity is about 40-55%.

6. Operate the Appliance

6. Plug the mains plug into a mains electricity
7. Turn control knob 4 clockwise beyond the
8. Regulate the intensity of humidification at
9. Turn mist outlet 1 in the desired direction.
10. Check humidity regularly using the hygro-

6.2 Switching the Appliance Off

1. Switch off the humidifier by turning control
2. Empty water tank 3 and base of the appliance
8
room. To do this, place the instrument
about 1m away from the humidifier and as
far away as possible from any direct source
of heat like a radiator or the sun.
supply socket (220–240V~/50Hz) (Figure 6).
noticeable resistance (Figure 6).
The appliance is now switched on and
indicator lamp 5 comes on. Steam becomes
visible within a few seconds.
control knob 4 (Figure 7).
thermometer (moisture and temperature
measuring instrument) supplied. Humidity
should be between 40 and 55%.
knob 4 anticlockwise beyond the noticeable
resistance (Figure 8).
The appliance is now switched off and
indicator lamp 5 goes out.
9 in the direction of the arrow (Figure 9) after
every use, especially if the appliance is not to