Publicidad
WPE 44
MANUAL DE USUARIO
VERSIÓN 1.5
CrossOver
/out[x]/xover,[y][z][a][b][c][d]
//out[x]/xover;iiiiff;[y];[z];[a];
[b];[c];[d];
Limiter /
/out[x]/Dynamic,[y][z][a][b][c]
Compressor
[d][e][f][g][h][i][j][k][l][m][n]
//out[x]//dynamic;ffffffffffffFFF
F;[y];[z];[a];[b];[c];[d];[e];[f];
[g];[h];[i];[j];[k];[l];[m];[n];
2
Bypass=0, Peak = 1, Low pass=2, High pass=3, Low shelving=4, High shelving=5, Band pass=6, Notch=7,
All pass=8
WPE SERIES
[z]
= Filter Type
[a]
= frequency (Hz)
[z]
= Gain (dBs)
[z]
= Quality factor
[0.01,10]
iiiiff
[x]
= Output channel
[y]
= High pass type
[z]
= Low pass type
[a]
= High pass Type
order
[b]
= Low pass Type
order
[c]
= High pass cut
frequency
[d]
= Low pass cut
frequency
f, f, f,
[x]
= Output channel
f, f, f,
[y]
= Attack time
f, f, f,
f, f, f,
[z]
= Release time
T/F,
T/F,
[a]
= Gain
T/F,
[b]
= Noise gate ratio
T/F
[c]
= Lineal threshold
[d]
= Compression
ratio
www.workpro.es
2
Establecer filtros
de crossover
Establecer
dinámica
19
Publicidad
