Descargar Imprimir esta página

Hendi 209424 Manual Del Usuario página 8

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 123
Cleaning and maintenance
• Always disconnect the electrical parts from the
mains before cleaning the appliance.
• Beware: Never immerse the appliance in water
or any other liquid!
• Clean the outside of the appliance with a damp
cloth (water with mild detergent).
Troubleshooting
Fault
Appliance does not work
at all
Appliance does not heat up Green switch indicator is lit
Appliance does not reach
the set temperature
EN
If after these controls, the malfunctioning continues, it is advisable to contact your supplier for assistance.
In case of any doubt, always contact your supplier!
Technical specification
Item no.
Operating voltage and frequency
Rated power
Protection class
Waterproof protection class
Temperature range
Ambient temperature
Capacity
Dimensions
Net weight (approx.)
Remarks: Technical specification is subjected to change without prior notification.
8
Symptoms
Green switch indicator
not lit & orange heating
indicator not lit
& orange heating indicator
not lit
Green switch indicator is lit
& orange heating indicator
is lit, but excessive frying
time or temperature
380-415V 3N~ 50/60Hz
• Never use aggressive cleaning agents, abrasives
or chlorinated cleaners. Do not use any sharp or
pointed objects. Do not use petrol or solvents!
Clean with a damp cloth and detergent if neces-
sary. Do not use abrasive materials.
Possible cause
Control panel not seated
properly on bracket
No mains power
Appliance is switched off
Microswitch defective
AC contactor defective
Thermostat set to a low
temperature
Hi-limiter (thermal cut-
out) tripped.
Hi-limiter (thermal cut-
out) defective.
Thermostat defective
Thermostat defective
209424
6600 W
Class I
IPX3
50 - 190°C
5 - 45˚C
10 L
302x687x(H)375mm
12 kg
Possible solution
Properly seat the control panel
on the bracket
Check the electrical installation
Switch on the appliance
Contact your supplier
Contact your supplier
Set the thermostat to a higher
temperature
Reset the Hi-limiter (thermal
cut-out) (See RESET on page 5)
Contact your supplier
Contact your supplier
Contact your supplier

Publicidad

loading