Publicidad
9. Maintenance
Maintenance, replacement, or repair of the emission control device and systems may be performed by any
non-road engine repair establishment or individual.
WARNING
• Always be sure to stop the engine before inspecting the stick edger for problems or performing
maintenance.
• Never alter the stick edger or take the engine apart.
• When replacing parts, always be sure to use only RedMax products or products which have been
certified by RedMax for use with the RedMax stick edger.
■ BE SURE TO CHECK THE FOLLOWING BEFORE USING YOUR STICK EDGER
1
Edging mechanism
2
Throttle
3
Throttle wire
4
Engine attachment
5
Fuel tank
6
Muffler
7
Cutting blade
40
Item to be checked
• See if attachment is loose
• Check if edges of blades are dull
• Stiff and difficult to move
• Too loose, too tight
• Stiff and difficult to move
• See if fittings are loose
• See if attachment is loose
• See if fuel pipe is damaged
• See if cap packing is damaged
• See if attachment is loose
• See if damaged or worn shorter than usable
length
Response
• Tighten screws and bolts
• Sharpen or replace blades
• Repair or replace
• Adjust
• Repair or replace
• Tighten fittings
• Tighten screws and bolts
• Replace
• Replace
• Tighten screws and bolts
• Replace
English
Publicidad
