Engine Operation; Starting The Engine; Starting A Cold Engine - Echo DM-6110 Manual De Instrucciones

Starting the engine

Be particularly careful to observe the following precautions when starting the engine:
Move at least 3m from the place where you refueled.
Place the product in a flat, well ventilated place.
Check that there are no fuel leaks.
Check that none of the nuts and bolts are loose.
Leave plenty of space around the product and do not allow people or animals near it.
Take precautions to keep hair from being drawn into fan.
Start the engine on the ground with the throttle lever at start position.
Hold the product firmly to the ground when starting the engine.
Failure to observe the precautions could cause an accident or injury, or even lead to a fatality.
Check that there are no abnormal vibrations or sounds once the engine starts. Do not use the product if there are
abnormal vibrations or sounds. Contact your dealer to have it repaired.
Accidents involving parts that fall or shatter off can cause wounds or serious injury.
The exhaust fumes from the engine contain toxic gases. Do not operate the product indoors or in other
ill ventilated places.
The exhaust fumes could cause poisoning.
Do not touch silencer, spark plug, and other high temperature components while the product is running
or for some time after it stops.
You could burn yourself if you touch a high temperature component.
Do not touch spark plug, spark plug wire, and other high voltage components while the product is run-
ning.
You could receive an electric shock if you touch a high voltage component while the product is running.
Pull out the starter grip gently at first, and then more rapidly. Do not pull the starter rope out to more than 2/3 of its length.
Do not let go of the starter grip as it returns.

Starting a cold engine

Engine operation

Engine operation
WARNING
NOTE
(Connect the spark plug cap if the product has been in storage for
a long period of time.)
1. Move choke lever (A) up to CLOSED position.
2. Move shutter control lever (B) down to CLOSE position
(duster) or close valve (mister).
3. Push purge bulb (C) until fuel is visible in clear fuel return line
(D).
4. Move throttle control lever (E) to START position (F) 1 or 2
and securely hold the machine, pull starter girp (G) several
times until first firing sound.
5. Move choke lever down to OPEN position. Restart the en-
gine and allow to warm up for a few minutes, before using.
13