fadini HINDI 880 - evo Manual De Instrucciones página 18

HINDI 880 - evo
FIXING GEOMETRY FOR THE GATE TO OPEN OUTWARDS
It is always recommended, before the operator fixing is finally completed, that a few manual
!
tests be carried out with Hindi 880-evo to assess that the installation distances are correct.
FIXING THE OPERATOR
Once finished with the mounting plates, unscrew the ball bearing eye by 5-6 mm (the center distance with the locknut to be
25-30 mm): in this way a certain amount of thrust force to close direction is ensured with the gate/s in closed position.
Important: eventually tighten the locknut hard with the help of the holding spanner supplied with the equipment.
Fasten Hindi 880-evo on to the mounting plates by means of the supplied bolt and circlips (Pic. 9).
universal oil-hydraulic operator for swing gates
A
Fixing distances for 95° opening
stroke (mm)
280
400
Holding spanner included: it allows for
the piston shaft to be hold steady while
the locknut is being tightened
!
NOTE WELL:
Tighten the locknut
hard by means of a
19 wrench
80 (with 280 mm stroke)
100 (with 400 mm stroke)
A
100 170
180 210
Operator rear
fixing
18
Closed position
gate stop
B
Operator front
fixing
Pic. 8
Pic. 9