Makita XWT11 Manual De Instrucciones página 7

Reversing switch action
A
1
► 1. Reversing switch lever
Changing the impact force/mode
2
3
4
5
► 1. Changed in four steps 2. Hard impact mode
3. Medium impact mode 4. Soft impact mode
5. Reverse rotation auto stop mode 6. Button
Specifications of each impact force grade
Impact force grade displayed
on panel
Hard
Medium
Soft
B
1
6
Maximum blows
-1
3,500 min (/min)
-1
2,600 min (/min)
-1
1,800 min (/min)
CAUTION:
Always check the direction of
rotation before operation.
CAUTION:
Use the reversing switch only after
the tool comes to a complete stop. Changing the
direction of rotation before the tool stops may dam-
age the tool.
CAUTION:
When not operating the tool,
always set the reversing switch lever to the neu-
tral position.
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for coun-
terclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
You can change the impact mode in four steps: hard,
medium, soft, and reverse rotation auto stop mode.
To select the step, press the button
For approximately one minute after releasing the switch
trigger, the impact force can be changed.
Hard, Medium, and Soft impact mode allows a tighten-
ing suitable to the work.
The function of reverse rotation auto stop mode works
only with pulling the trigger fully in counterclockwise tool
rotation. When the bolt/nut gets enough loosened, the
tool stops the impact and rotation.
Application
Tightening when force and
speed are desired.
Tightening when you need
good controlled power.
Tightening when you need fine
adjustment with small diameter
bolt.
7 ENGLISH
.
Work
Assembling the steel frame.
Assembling or disassembling
scaffolds or framework.
Assembling furnitures.