Nikkei NL24MANDROID Manual Del Propietário página 48

Turning On/Off the TV
Connect power
IMPORTANT: The TV set is designed to operate on
a 12 V DC supply. For this, an adaptor is used which
gives 12 V voltage.
After unpacking, allow the TV set to reach the ambient
room temperature before you connect the set to the
mains.
Connect the supplied adaptor to a system that
supplies 100-240V AC, 50/60Hz. The TV will switch
on automatically.
In order to supply the power via the cigarette lighter
socket of your vehicle, plug one end of the cigarette
lighter adaptor cable (car plug - can be purchased
separately if not supplied with the TV) into the vehicle
socket and plug the other end of the adaptor cable
into the DC 12V terminal on the back side of the TV.
Be sure to ground the connection
Connect the ground terminal of the AC
adaptor with the ground terminal provided at
the power outlet using the enclosed power
cord. If the provided plug does not fit your
outlet, consult an electrician for replacement
of the obsolete outlet.
Surely connect the ground wire.
To switch on the TV from standby
If the TV is in standby mode the standby LED lights
up. To switch on the TV from standby mode either:
• Press the Standby button on the remote control.
• Press the centre of the control switch on the TV in.
The TV will then switch on.
To switch the TV into standby
The TV cannot be switched into standby mode via
control switch. Press and hold the Standby button on
the remote control. Power off dialogue will appear on
the screen. Highlight OK and press the OK button. The
TV will switch into standby mode.
To switch off the TV
To power down the TV completely, unplug the power
adaptor from the mains socket.
Quick Standby Mode
In order to switch the TV into quick standby mode
either;
• Press the Standby button on the remote.
Press again to go back to operating mode.
properly
• Press the centre of the control switch on the TV in
and hold it down for a few seconds.
Press again to go back to operating mode.
TV Control & Operation
The control switch allows you to control the Programme
and Quick Standby-On functions of the TV.
Note: The position of the control switch may differ depending
on the model.
To change channel in Live TV mode: Press the
centre of the control switch in, the information banner
will appear on the screen. Scroll through the stored
channels by pushing the control switch up or down.
To turn the TV off (Quick Standby): Press the centre
of the control switch in and hold it down for a few
seconds, the TV will turn into quick standby mode.
To turn the TV off (Standby): The TV cannot be
switched into standby mode via control switch.
To turn on the TV: Press the centre of the control
switch in, the TV will turn on.
Note: Live TV settings menu OSD in Live TV mode cannot be
displayed via control switch.
Operation with the Remote Control
Press the Menu button on your remote control to
display Live TV settings menu when in Live TV mode.
Press Home button to display or return to the Home
Screen of the Android TV. Use the directional buttons
to move the focus, proceed, adjust some settings and
press OK to make selections in order to make changes,
set your preferences, enter a sub-menu, launch an
application etc. Press Return/Back to return to the
previous menu screen.
Input Selection
Once you have connected external systems to your
TV, you can switch to different input sources. Press the
Source button on your remote control consecutively
or use the directional buttons and then press the OK
button to switch to different sources when in Live TV
mode. Or enter the Inputs menu on the Home Screen,
select the desired source from the list and press OK.
Changing Channels and Volume
You can adjust the volume by using the Volume
+/- buttons and change the channel in Live TV mode
by using the Programme +/- buttons on the remote.
English - 8 -