Machine Start And Stop; Starting The Machine; Stopping The Machine; Adjusting The Level Of Orbital Deck(Only For Orbital Machine) - Clarke CA60 20B Instrucciones De Uso

INSTRUCTIONS FOR USE

MACHINE START AND STOP

Starting the machine

1. Prepare the machine as shown in the previous paragraph.
2. Insert the ignition key (A, Figure. 9) and turn it to "I".
Check that the green warning light (B) turns on (charged
battery). If the yellow (C) or red warning light (D) turns
on, turn the ignition key back to "0" and charge the
batteries (see the procedure in Maintenance chapter).
3. Drive the machine to the working area:
• By pushing it with the hands on the handlebar (E) (only
for machine without traction).
• By pushing it with the hands on the handlebar (E) and
pressing the switch (F) to move forward, or pressing the
switch (F) together with the switch (G) to move backward
(only for machine with traction). The forward speed can
be adjusted with the adjuster (H).
4. Lower the squeegee (I) with the lever (J).
5. Lower the brush/pad-holder deck (K) by lifting the pedal
(L). (only for disc machine)
6. Press the brush/pad-holder switch (M) and the vacuum
system switch (N).
7. Press the washing water flow control switches (O) as
necessary, depending on the type of cleaning to be
performed.
8. Start cleaning:
• (only for machine without traction) by pushing the
machine with the hands on the handlebar (E) and pressing
the switch (F).
• (only for machine with traction) by pushing the machine
with the hands on the handlebar (E) and by pressing the
switch (F). If necessary, the forward speed can be adjusted
with the adjuster (H).
NOTE
To move the machine forward, press either
the left or right switch (F) or both.

Stopping the machine

9. Stop the machine by using the handlebar (E) (only for
machine without traction). Stop the machine by releasing the switches (F) (only for machine with traction).
10. Stop the brushes and the vacuum system by pressing the switch (M). The vacuum system stops after a few
seconds.
11. Lift the brush/pad-holder deck (K) by pressing the pedal (L). (only for disc machine)
12. Lift the squeegee (I) with the lever (J).
13. Turn the ignition key (A) to "0".
14. Make sure that the machine cannot move independently.
ADJUSTING THE LEVEL OF ORBITAL DECK
(only for orbital machine)
1. Lower the brush/pad-holder deck by press the brush/pad-
holder switch (M, Figure. 9)
2. Adjust the level of orbital deck by adjusting handle (A,
Figure 9.1) . made the bubble in the middle (B, Figure 9.1).
G D C
E
F
O M
K
I
B
12
ENGLISH
B A
F
N
Figure 9
A
B
Figure 9.1
H
J
L