Machine Operation (Scrubbering And Drying) - Clarke CA60 20B Instrucciones De Uso

INSTRUCTIONS FOR USE

MACHINE OPERATION (SCRUBBERING AND DRYING)

1. Start the machine as shown in previous paragraphs.
2. While keeping both hands on the handlebar press the safety switch (F, Figure. 9), then maneuver the machine and
start scrubbing/drying the floor.
3. If necessary, stop the machine then adjust squeegee according to section "Adjusting balance of squeegee".
NOTE
For correct scrubbing/drying of floors at the sides of the walls, Suggests to go near the walls with
the right side of the machine (A and B, Figure. 10) as shown in the figure.
CAUTION!
To avoid any damage to the floor surface, turn off the brushes/pad-holders when the machine
stops in one place.
Detergent flow adjustment
(For machines with Chemical Mixing System)
1. Turn the knob (A, Figure. 11) clockwise or counter-clockwise
to increase or decrease the detergent concentration.
2. The average detergent concentration values, matching the 4
colored areas of the scale (B), are shown in the figure.
3. To set the detergent quantity to zero, fully turn the knob (A)
counter-clockwise.
NOTE
The detergent concentration is kept constant
even if the washing water flow is changed with
the switches (C) or (D).
A
Figure 10
B
C
D
13
ENGLISH
1,5% 2,5%
0,4% 0,75%
B
A
Figure 11