Publicidad
Idiomas disponibles
Idiomas disponibles
With the first recommended method,
the chainsaw is started on the ground.
Make sure the chain brake is engaged
(see "Chain Brake" chapter in your
instruction manual) and place the
chainsaw on firm ground or other solid
surface in an open area. Maintain good
balance and secure footing.
Grip the front handlebar of the saw firmly
with your left hand and press down. For
saws with a rear handle level with the
ground, put the toe of your right foot into
the rear handle and press down. With
your right hand pull out the starter grip
slowly until you feel a definite resistance
and then give it a brisk, strong pull.
MS 441 C
The second recommended method for
starting your chainsaw allows you to
start the saw without placing it on the
ground. Make sure the chain brake is
engaged. Grip the front handle of the
chainsaw firmly with your left hand, keep
your left arm in a locked (straight)
position. Hold the rear handle of the saw
tightly between your legs just above the
knees. If you are using the rear-handle-
activated chain brake, be careful not to
disengage the brake by depressing the
interlock lever with your leg. Maintain
good balance and secure footing. Pull
the starting grip slowly with your right
hand until you feel a definite resistance
and then give it a brisk, strong pull.
!
Warning!
Be sure that the guide bar and chain are
clear of you and all other obstructions
and objects, including the ground. When
the engine is started, the engine speed
with the starting throttle lock engaged
will be fast enough for the clutch to
engage the sprocket and, if the chain
brake is not activated, turn the chain. If
the upper quadrant of the tip of the bar
touches any object, it may cause kick-
back to occur (see section on reactive
English / USA
forces). Never attempt to start the
chainsaw when the guide bar is in a cut
or kerf.
As soon as the engine is running,
immediately blip the throttle trigger,
which will disengage the starting throttle
lock and allow the engine to settle down
to idle.
!
Warning!
As soon as you press down the interlock
lever, the rear-handle-activated chain
brake is disengaged and allows the
chain to run at high speed until you blip
the throttle trigger.
!
Warning!
When you pull the starter grip, do not
wrap the starter rope around your hand.
Do not let the grip snap back, but guide
the starter rope to rewind it properly.
Failure to follow this procedure may
result in injury to your hand or fingers
and may damage the starter
mechanism.
11
Publicidad
