Publicidad
Idiomas disponibles
Idiomas disponibles
ETF SL21-04-I06-T25
Stockholm, 6 March 2023
Carl von Schantz, Managing Director
Signature of issuer
Authorised Representative UK
James McAllister, General Manager
Atlas Copco Ltd
Swallowdale Lane
Hemel Hempstead
Hertfordshire HP2 7EA
Safety
DO NOT DISCARD - GIVE TO USER
WARNING Read all safety warnings, instructions, il-
lustrations and specifications provided with this prod-
uct.
Failure to follow all instructions listed below may result
in electric shock, fire, property damage and/or serious in-
jury.
Save all warnings and instructions for future refer-
ence.
WARNING All locally legislated safety rules regard-
ing installation, operation and maintenance shall be
respected at all times.
Statement of Use
• For professional use only.
• This product and its accessories must not be modified in
any way.
• Do not use this product if it has been damaged.
• If the product data or hazard warning signs on the product
cease to be legible or become detached, replace without
delay.
• The product must only be installed, operated and serviced
by qualified personnel in an industrial environment.
Intended Use
This product is designed for installing and removing threaded
fasteners in wood, metal or plastic.
No other use permitted.
Product Specific Instructions
Installation
General Installation Safety
• Always make sure that the drive unit/controller is
switched off before connecting/disconnecting the tool ca-
ble.
© Atlas Copco Industrial Technique AB - 9836 2718 00
• Always disconnect the tool from the drive unit/controller
before making any adjustments on or inside the tool.
• The tool with its drive/controller box is designed to oper-
ate at any setting within its torque range at a primary volt-
age of nominal 230V/ 50Hz alternatively 115V/ 60Hz,
single phase. Refer to the manual for the drive unit or
controller.
• Make sure that the tool is in good working order and that
the controller is correctly programmed before use to
avoid unexpected behavior from the tool which may re-
sult in operator injury.
Operation
General Operation Safety
WARNING All locally legislated safety rules regard-
ing installation, operation and maintenance shall be
respected at all times.
• Due to entanglement risk, do not wear gloves.
• Be prepared of the reaction force which will occur when
the tool is used.
• This product is only intended for industrial use and shall
only be operated indoor in dry rooms. This product must
not be used in explosive atmospheres.
• Only use power sockets.
• When using a suspension yoke, make sure that it is in
good condition and correctly fastened.
• Be prepared of the reaction force which will occur when
the tool is used.
• Make sure that the tool is in good working order and that
the controller is correctly programmed before use to
avoid unexpected behavior from the tool which may re-
sult in operator injury.
• Be aware of the rotational direction of the spindle before
starting the tool, the reaction force may work in an unex-
pected direction with risk of crush injuries.
• The tool with its drive/controller box is designed to oper-
ate at any setting within its torque range at a primary volt-
age of nominal 230V/ 50Hz alternatively 115V/ 60Hz,
single phase. Refer to the manual for drive unit.
• Always keep the drive unit/controller locked.
• The tool is intended for intermittent use. A typical operat-
ing cycle is 1 s on, 4 s off. This may vary substantially
depending on the application. The acceptable duty cycle
depends on many factors including torque and joint type.
The tool contains protective mechanisms that ensure that
the acceptable duty cycle is not exceeded.
• Avoid using tightening strategies in applications outside
their limitations.
• Major changes in joint characteristics will affect the oper-
ator reaction force.
• Consider that a joint failure or a tool error can cause sud-
den unexpected reaction force and possibly injure the op-
erator.
• Recommended value for Rundown Complete is 10% of
target torque.
Safety Information
5
Publicidad
