HAMPTON BAY 51360 Guía De Uso Y Mantenimiento página 11

Assembly - Attaching the Light Kit
6
Attaching the light kit
CAUTION: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light kit.
□
Remove the three screws (QQ) from the light kit fitter
assembly (E) below the fan motor assembly (D).
□
Connect the wires exiting the bottom of the motor assembly
(D) by connecting the molded adaptor plugs (SS) together
(black to black, white to white).
□
Slide the switch cup light kit (E) and secure it to the switch
housing using the three screws (QQ) that were removed in
the first step.
7
Installing the bulbs and attaching the
glass bowl
CAUTION: Make sure the power is off before attaching or
removing the glass bowl.
WARNING: Allow the glass bowl to cool completely before
removing.
□
Remove the finial from the switch cup/light kit assembly.
□
With power off, install the two bulbs (I) by twisting them
into the light bulb sockets. Position the glass bowl (H) over
the threaded nipple and pass the pull chain for the fan
through the hole under the glass bowl (H).
□
Re-install the finial.
□
Attach the pull chain extension (FF).
CAUTION: Over lamping the fan will result in the fan lights
shutting down until the proper wattage bulbs are installed. Reset
the lights by turning off the power, replacing the bulbs with the
correct wattage bulbs, and turn the power on.
QQ
I
11
Please contact 1-877-527-0313 for further assistance.
D
SS
E
H
FF
HAMPTONBAY.COM