Sony XM-6ES Manual De Instrucciones página 9

GROUND terminal
• Be sure to connect the ground (earth) lead
securely to a metal point on the car chassis. A
loose connection may cause the amplifier to
malfunction.
• During full-power operation, a current of more
than 120 A will run through the system. Therefore,
make sure the leads to be connected to the
GROUND terminal are at least 1-Gauge (AWG-1) or
have a sectional area of more than 43 mm²
(1 3 / in²).
4
REMOTE terminal
• To turn on the amplifier using a dedicated remote
turn-on lead, set the TURN-ON switch to
"REMOTE", then connect the remote output
(REMOTE OUT) of your car audio or DSP to the
REMOTE terminal.
• When using a car audio or DSP without a remote
output (REMOTE OUT) for the amplifier, connect
the REMOTE terminal to the ACC power supply of
your car or use the signal sensing turn-on setting
instead.
• Use a remote turn-on lead with a thickness from
AWG-8 to AWG-18 or a sectional area from
8.4 mm² ( 11 / in²) to 0.82 mm² (
32
Notes on using high-level sensing turn-on
settings
• In high level input connection, the amplifier can
also be activated without the need for a REMOTE
connection. However, this function is not
guaranteed for all car audio or DSP.
• By setting the TURN-ON switch to "SIGNAL", the
amplifier operates automatically when a turn-on
signal is received from the INPUT connector.
1 / in²).
16
Input Connection
Connect to the INPUT connector using a  low-
level input connection or  high-level input
connection depending on your car audio or DSP.
 Low-level input connection
Set the INPUT VOLTAGE switch to "LOW" and
connect the RCA extension cable (not supplied)
from your car audio or DSP to the INPUT connector.
INPUT
VOLTAGE
LOW HIGH
* RCA extension cable (not supplied)
 High-level input connection
Set the INPUT VOLTAGE switch to "HIGH" and use a
speaker-wire-to-RCA adaptor (not supplied) to
connect the speaker wire from your car audio or
DSP to the INPUT connector.
Car audio or DSP
*
INPUT
VOLTAGE
LOW HIGH
* Speaker-wire-to-RCA adaptor (not supplied)
Car audio or DSP
*
Speaker output
(left)
Speaker output
(right)
9
EN