Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLING LOGS
VL-WO18D/VL-WO24D/VL-WO30D/VL-SA18D/VL-SA24D/VL-SA30D
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts
specifically approved with this log set may result in property damage or personal injury.
CAUTION: After installation and periodically thereafter, check to ensure that no yellow flame comes in
contact with any log. With the log set set to High, check to see if yellow flames contact any log. If so,
reposition logs according to the log installation instructions in this manual. Yellow flames contacting
logs will create soot.
It is very important to install the logs exactly
as instructed. Do not modify logs; use only logs
supplied with log set. Each log is marked with a
number, and this number will help you identify
each log during installation.
NOTE: These log installation instructions are recom-
mended to decrease the amount of sooting the most.
Fig. 9 - Installing Risers
Back of grate
1. After optional acces-
sories are installed (see
previous page), slide
both risers onto the
back of the grate. Make
sure the back of the
grate is flush with the
back of the riser.
Fig. 13 - Installing Log #4
4. Place log #4 so it is
resting on the top right
of logs #1 and #2.
Fig. 10 - Installing Log #1
1
2. Place log #1 on
the top of the front
grate and make
sure the log is cen-
tered in the grate.
Fig. 14 - Installing Log #5
4
5. Place log #5 so it
is resting on logs #3
and #2 only.
Provided Logs: 6
1
Fig. 11 - Installing Log #2
2
3. Carefully place log
#2 on the top of the
risers. Make sure the
log is centered on top
of the risers.
5
12
2
3
4
5
6
Fig. 12 - Installing Log #3
3
3. Place log #3 so it is
resting on the top left
of logs #1 and #2.
Fig. 15 - Installing Log #6
6
6. Place log #6 so that it is
resting on logs #1 and #4.
Publicidad
