Using The Vise Clamp - skilsaw SPT84 Instrucciones De Funcionamiento Y Seguridad

USING THE VISE CLAMP

Changing Cutting Angle
1. Loosen the vise-stop adjustment bolts with the
wrench provided, (Fig. 9), DO NOT REMOVE
the bolts .
2. Align the desired angle on the vise-stop scale
with the index line in the base, and securely
tighten the bolts with the wrench .
NOTE: The cutting angle can be adjusted with-
in ±45 degree.
Maximum Cutting Depth
To obtain maximum cutting depth, position vise
stop so that the material being cut is approxi-
mately centered under the wheel when wheel
is lowered all the way down.
FIG. 9
Vise Handle
Screw Shaft
Operating Instructions
Quick-Release
Vise Clamp
Lever
Base
Vise-Stop
Adjustment
Bolts
To reposition the vise stop:
1. Loosen and remove the vise-stop adjustment
bolts with the wrench provided (Fig. 9).
2. Move vise stop to desired location holes, install
and securely tighten the bolts with the wrench.
Quick-Release Lever
To release the work, turn the vise handle to
loosen it, lift the quick-release lever up (Fig. 9),
and pull the screw shaft away from the work.
To lock the workpiece in place, push the screw
shaft toward the workpiece, lower the quick-re-
lease lever and turn the vise handle clockwise
to tighten it .
Vise Stop
Scale
-17-
Additional Vise-Stop
Mounting Holes
Index Line