Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACEMENT PARTS AND ACCESSORIES
If your dryer requires replacement parts or accessories, contact the dealer from whom you purchased your
dryer or the SAMSUNG customer care center at
INSTALLATION
Gather the required tools and parts before starting the installation.
Read and follow the instructions provided with any tools listed here.
Tools and Parts
Pliers
Level
For proper installation, we recommend that you hire a professional. To install:
1. Move your dryer to an appropriate location for installation. Consider installing the dryer and washer side
by-side. This will allow access to gas, electrical, and exhaust connections.
Lay two of the carton cushion-tops on the floor. Tip your dryer on its side so it will lay across both
cushion-tops.
2. Set your dryer back in an upright position.
3. To ensure that the dryer provides optimal drying performance, it must be level. To minimize vibration,
noise, and unwanted movement,the floor must be a perfectly level, solid surface.
To set the dryer to the same height as the washer, fully retract the
leveling feet by turning them counterclockwise, then loosen the legs
by turning them clockwise
Adjust the leveling feet only as much as necessary to level the dryer.
Extending the leveling feet more than necessary can cause the dryer
to vibrate.
DV220AE-02810A-10_EN.indd Sec11:15
DV220AE-02810A-10_EN.indd Sec11:15
1-800-SAMSUNG(726-7864
Cutting knife
Phillips Screwdriver
Retract fully
Then loosen
).
Pipe wrench (gas only)
Duct tape
Leveling feet
installing your dryer _15
Nut drivers
Wrench
Level
2013-04-23
2013-04-23
3:39:50
3:39:50
Publicidad
