Publicidad
Idiomas disponibles
Idiomas disponibles
Burner grates and components
Turn off all surface burners and make sure they have all cooled down.
1
2
3
8
7
6
FULL_RANGE TOP_DTT48T960GS_DG68-01474A-01_EN+MES+CFR.indb 37
FULL_RANGE TOP_DTT48T960GS_DG68-01474A-01_EN+MES+CFR.indb 37
1. Remove the burner grates.
2. Remove the burner caps from the
burner heads.
3. Remove the burner heads from the
valve manifolds to reveal the starter
electrodes.
4. Clean the grates and burner
components in warm, soapy water. (Do
not use steel-wool pads or abrasive
cleaners.)
5. Rinse and dry grates and burner
components thoroughly.
6. Reassemble the burner heads, making
sure to insert a starter electrode
through the hole in each head.
NOTE
See Pages 40-42 for details on how
to reassemble the burner components.
7. Reassemble the remaining burner
components, making sure the caps lie
flat on top of the heads.
8. Re-install the burner grates in their
respective positions.
9. Turn on each burner to verify that
it works properly, then turn off the
burner.
English 37
2023-04-25 오후 6:03:39
2023-04-25 오후 6:03:39
Publicidad
