Probuilder 56149 Manual De Instrucciones página 30

screws in the same material. Turn the
torque selector to the desired setting.
The higher the setting, the more torque is
allowed before the screwdriver switches
off.
CHECKING THE BATTERY
You can check the battery charge level by
pressing the button (6) and reading the
LEDs in the battery indicator (5).
If the red, yellow and green are lit: the
battery is fully or almost fully charged.
If the red and yellow light are lit: the
battery is partially charged.
If only the red light on: the battery needs
to be charged.
USE
Insert the desired bit directly into the
screwdriver bit holder (1) or use the
magnetic holder as an extension between
bit holder and bit.
Select the direction of rotation by
pressing the switch (4) to the right or left.
In the centre position the on/off switch is
blocked to prevent accidental starting.
Switch the screwdriver on and off
using the on/off switch (7). When the
screwdriver is running, the work light
switches on automatically.
CLEANING AND MAINTENANCE
Clean the screwdriver with a hard-wrung
cloth after use and always keep its surface
and ventilation openings free of dirt.
Do not use corrosive or abrasive cleaning
agents, as these may attack the plastic
parts of the screwdriver.
If the screwdriver is not going to be used
for a long period of time, charge it fully
before putting it away for storage. Charge
it at least every 3 months to preserve the
capacity of the battery.
30