Publicidad
Idiomas disponibles
Idiomas disponibles
2. HOW TO USE
PARTS
A. Steam regulati ng knob
B. Burst of steam butt on
C. Spraying butt on
D. Indicator bulb
E. 360º swivel cord
F. Temperature regulati ng
knob
G. Water tank
H. Ceramic coati ng soleplate
I. Spraying mouth
J. Cover of water fi lling mouth
K. Self-clean butt on
L. Auto-Shut off light
HOW TO FILL WITH WATER
Make sure the iron is turned off and the power cord cord os unplugged from the electri-
cal outlet.
1. Set the "Variable"steam knob to the 0 positi on before fi lling the iron with water.
2. Open the "Water fi ll" opening and fi ll the tank to the "MAX" line on the tank.
3. The water level can be observed through the transparent part of the tank, when
the iron is placed verti cally. In case of the water level becomes low, refi ll the tank
following the procedure described before.
4. Pour out the remaining water aft er use.
Note:
Most tap water can be used in this iron. Do not use water additi ves or substi tute water
such as linen or scented water in the steam iron, they can stain fabrics or damage the
iron. Do not fi ll the water more than the "MAX" positi on.
HOW TO USE AS DRY IRON
1. Positi on the iron verti cally.
2. Plug the iron.
3. Set the temperature control dial to the "MIN" positi on.
4. Preheat the iron unti l the indicator light goes out.
Publicidad
