Front Panel; Rear Panel - Monacor International JTS IN-164R /5 Manual De Instrucciones

Diversity UHF Receiver
These instructions are intended for users without
any specific technical knowledge Please read these
instructions carefully prior to operating the unit and
keep them for later reference
All operating elements and connections de-
scribed can be found on the fold-out page 3
1 Overview

1.1 Front panel

1 Receiving antennas
2 Volume control for the audio signal at the
6 3 mm output jack (9) and at the XLR out-
put (11)
3 Button REMOSET to set the transmitter to the
group and the channel of the receiver
☞
chapter 5 2
4 LC display
a indication RF (radio frequency) for the
power of the radio signal received
b indication AF (audio frequency) for the vol-
ume of the audio signal received
c diversity indication
of the two antennas receives the more
powerful radio signal
d battery symbol to show the status of the
batteries in the transmitter in 4 levels
e indication LOCK when the lock function has
been activated
f indication MUTE when the muting function
has been activated
muting activated when
– no radio signal is received from the trans-
mitter or when the signal is poor
– the transmitter has been muted
(possible for transmitter IN-264TH / 5 only)
g indication of the channel group
h indication of the channel
5 Button ▼
: in the setting modes to search in
descending order when selecting the group,
the channel and the identification number and
to deactivate the scan function and the lock
function
or to show which
A B
6 Button SET
to activate the setting modes one after another
group (keep button pressed for a while)
 channel  scan function  identifica-
tion number  lock function
and to confirm the settings
Note: When the lock function has been activated
[indication LOCK (e)], you will only be able to acti-
vate the setting mode for the lock function (
ter 5 1 4)
7 Button ▲ : in the setting modes to search in
ascending order when selecting the group, the
channel and the identification number and to
activate the scan function and the lock function
8 On /off switch

1.2 Rear panel

9 Audio output via 6 3 mm jack (bal ) to con-
nect a microphone input or highly sensitive line
input, e g of a mixer or amplifier
10 Switch to attenuate the level of the signal at
the XLR output (11) by 20 dB (position MIC )
11 Audio output via XLR chassis plug (bal ) to
connect a microphone input or highly sensitive
line input, e g of a mixer or amplifier
12 Squelch control to adjust the squelch threshold
13 Strain relief for the cable from the power sup-
ply unit
14 Power supply jack to connect the power supply
unit provided
15 BNC jacks for the antennas (1) provided
☞ chap-
9