BWT D300 Manual De Instrucciones página 4

Operation
Starting the Robotic Cleaner
Connect the power supply to the wall socket. The on/off button is lit and the robotic
cleaner starts its cleaning program. If the power and control unit is already connected
to the AC socket, the on/off button flashes to indicate that the robotic cleaner is in
standby mode. Press the Operation button. The on/off button turns on and the robotic
cleaner starts the cleaning program. Note: When the Full Filter Indicator light on
(optional in some models.) the filters must be cleaned before replacing the unit in the
pool.
Cleaning Cycle
During the cleaning cycle, the cleaner: (1) moves across the pool floor picking up dirt
and debris. (2) Changes direction and rotates automatically according to the selected
program. (3) Climbs the pool walls every few minutes, as set in its internal program.
Note: The robotic cleaner might occasionally stop moving for a few seconds. This is
part of normal operation, not a malfunction.
Stopping robotic cleaner operation
The robotic cleaner moves automatically to 'standby' after every cleaning cycle and
the on/off button starts flashing. To stop the cleaner operation during a cleaning cycle,
press the operation button once. The on/off button starts flushing and the cleaner is in
standby mode.
Pulling cleaner unit out of the water
(1) Unplug the floating cable from the power supply. (2) Pull the floating cable until the
unit is close enough to reach the handle. (3) Using the handle, lift the cleaner out of the
pool.
CAUTION: Do not use the floating cable to lift the cleaner unit out of the water.
4
D300 ROBOTIC POOL CLEANERS
Power Supply
On/Off
Full filter
indicator
Bluetooth
D300