Draining The Unit; Cleaning Instructions For The Faucet; Machine Disposal - ASBER Slim Line ABBC/DD-24-36 Manual De Instrucciones

4.2.3 Draining the Unit

Each unit has a drain located inside the unit which removes the condensation from the
evaporator coil and evaporates it at an external condensate evaporator pan. Each drain can
become loose or disconnected from moving or bumping the drain.
IF YOU NOTICE EXCESSIVE WATER ACCUMULATION ON THE INSIDE OF THE UNIT be
sure the drain tube is connected from the evaporator housing to the condensate evaporator
drain pan.
IF WATER IS COLLECTED UNDERNEATH THE UNIT you may want to check the condensate
evaporator drain tube to be sure it is still located inside the drain pan. The leveling of the unit is
important as the units are designed to drain properly when on a level surface, if your floor is not
level this can also cause drain problems. Be sure all drain lines are free of obstructions; typically
food product is found blocking drain lines causing water to back up and overflow the drain pans.

4.2.4 Cleaning Instructions for the Faucet

Proper cleaning is important for the beer faucet, drain pan or any item coming in contact with
food or beverages to prevent odors and tastes from bacteria. Prior to removing the faucet for
cleaning, close the tap valve at the keg.
The faucet should be cleaned every week. Using the spanner wrench provided, remove the
faucet from the shank and thoroughly clean with hot water and detergent. Rinse completely and
reinstall the faucet.(Note: The faucet may be taken apart for more thorough cleaning.)
NOTICE
This cooler is designed to maintain your beer keg temperature with in the most desirable range
of 35° to 40°F. You can expect this temperature with the proper temperature control setting and
in a normal environment. It is important to understand that when the keg of beer is purchased, it
must be installed inside the cooler as soon as possible to avoid excessive warm-up of the beer.
If this happens, it may take many hours for the temperature to be reduced to the desirable
range.

Machine disposal

4.3
The product's life-cycle is around 7 to 10 year from the first use and operation date.
Asber equipment is manufactured without dangerous or toxic materials. Some parts of the equipments
are biodegradable.
The disposing after the product's life-cycle shall be determined by the customer according to the
rules and laws established in the city or State of residence.
REMEMBER TO TAKE CARE OF THE ENVIRONMENT.
8
asberprofessional.com
asberprofessional.com