Ryobi RY40800 Manual Del Operador página 263

CO SENSOR SPECIFIC SAFETY RULES
 NEVER ignore an automatic shutoff event. IF AUTOMATIC
SHUTOFF OCCURS – YOU MUST leave the area imme-
diately and relocate to an open outdoor area. Ventilate
the area thoroughly before occupying again. Ensure the
generator is located in an open, outdoor area. Always
point exhaust away from occupied structures. Never
run the generator in enclosed areas (e.g. not in a house
or garage). Failure to follow these instructions can lead
to carbon monoxide (CO) poisoning which can result in
death or serious personal injury.
 The carbon monoxide sensor on this generator is not
designed to detect smoke, fire, or any other gas. It will
only activate due to the presence of carbon monoxide
WARNING
DO NOT tamper with, adjust, or modify
the carbon monoxide (CO) sensor
module. Failure to follow these
instructions can cause the monitor to
malfunction which can result in death
or serious personal injury.
AVERTISSEMENT
NE PAS altérer, ajuster ou modifier le
module à capteur de monoxyde de
carbone (CO). Le défaut de suivre ces
instructions peut causer un mauvais
AVERTISSEMENT
fonctionnement du moniteur ce qui
peut entraîner la mort ou des
blessures graves.
ADVERTENCIA
NO altere, ajuste ni modifique el
módulo del sensor de monóxido de
carbono (CO). Si no sigue estas
instrucciones, el monitor podría no
funcionar correctamente, lo que puede
resultar en la muerte o lesiones
personales graves.
CO SENSOR ADDENDUM
RY906500S
This generator includes a carbon monoxide sensor. In addition to all the rules,
warnings, and instructions contained in your generator operator's manual, please
also read and understand the information included in this CO sensor addendum.
If you loan someone this product, loan them this addendum also.
CARBON MONOXIDE SENSOR WITH AUTOMATIC SHUTOFF
The generator's carbon monoxide sensor is designed to monitor the level of car-
bon monoxide present during generator operation. If the generator is positioned
incorrectly and carbon monoxide levels rise to an unsafe level, the LED on the
sensor will flash red and the generator will automatically shut down. Leave the area
immediately and relocate to an open outdoor area. Ventilate the area thoroughly
before occupying again. Ensure the generator is located in an open, outdoor area
and point exhaust away from occupied structures before restarting.
SYMBOLS
SAFETY LABELS
These additional safety labels are located on your genera-
tor. If any of the labels come off the unit or become hard to
read, contact customer service or a qualified service center
for replacement.
CARBON MONOXIDE (CO) SENSOR
In the event of a carbon monoxide hazard, the LED on the
CO sensor will flash red and the generator will shut off. Leave
the area immediately and relocate to an open outdoor area.
Ventilate the area thoroughly before occupying again. Ensure
the generator is located in an open, outdoor area. Always
point exhaust away from occupied structures. Never run the
generator in enclosed areas (e.g. not in a house or garage).
DO NOT tamper with, adjust, or modify the carbon monoxide
(CO) sensor module on your generator.
gas at the sensor. Carbon monoxide gas may be present
in other areas.
 The carbon monoxide shutoff feature on this generator
is not a substitute for safe generator practices. Always
operate the generator in open, outdoor areas, at least
20 feet away from occupied structures. Never operate the
generator in fully or partly enclosed areas or near open
windows, doors, or other unventilated spaces.
 DO NOT tamper with, adjust, or modify the carbon mon-
oxide (CO) sensor module on your generator. Failure to
follow these instructions can cause the monitor to mal-
function which can result in death or serious personal
injury.