Power Supply Connection; Operating The Pressure Washer - AllTrade TRADES PRO 830271 Manual De Instrucciones

cold water (less than 100 F) and adequate pressure (no less than 50 PSI).
KEEP all electrical connections dry and off the ground.
NEVER touch the plug with wet hands.
NEVER cut or remove grounding blade (round longer pin) on GFCI
attachment plug.
1. Connect the Pressure Washer GFCI power cord to a dedicated electrical outlet.
2.To ensure for GFCI proper operation:
a. Plug into receptacle: indicator should be "ON"
b. Press Test Button: Indicator should be "OFF"
c. Press Reset Button for use. Do not use if test fails
when TEST button is pressed. Call Customer Service 1-800-423-3598.
ALWAYS wear approved safety glasses when operating Pressure
Washers. Spray can splash back or propel objects, including
incorrectly attached accessories.
The high pressure stream of water that this equipment
produces can cut through skin and its underlying tissues, leading to
possible amputation.
Spray gun traps high water pressure, even when the motor
is stopped and water is disconnected, which can cause injury.
Kickback from spray gun can cause you to fall.
For best result, use a short garden hose (30 ft. or less length),

POWER SUPPLY CONNECTION

Outlet capacity must be 120V, 60HZ and minimum 15 AMP.
Do NOT use the pressure washer if RESET button does not pop out

OPERATING THE PRESSURE WASHER

13
RESET
TEST