Maintenance - AllTrade TRADES PRO 830271 Manual De Instrucciones

Regular maintenance will improve performance and extend life of Pressure Washer.
Pressure Washer' s warranty does not cover items that have been subjected to operator abuse or
negligence. Only by maintaining Pressure Washer in accordance with instructions in this manual
will the full value of the warranty be honored.
Some adjustments will need to be made periodically to properly maintain the Pressure Washer.
All service and adjustments should be made at least one time each season. It is important that the
maintenance chart below be followed.
STORAGE
After each application or winter storage follow these instructions:
1. When finished using the Pressure Washer, you must first drain and rinse the detergent
bottle and siphoning tube.
2. Run the Pressure Washer in low pressure until all of the soap is drained from the detergent
bottle.
3. Pour clear water into the bottle and run it through on low pressure as though it were deter-
gent.
4. Turn the machine OFF and squeeze the trigger to release the trapped pressure inside of the
machine.
5. Remove both the garden hose and high pressure hose from the unit.
6. Turn ON the machine and allow it to run for 5 seconds. (This will clear out most of the
water trapped in the pump).
7. Unplug the machine and store in a dry, climate controlled environment.
NOTE: Do not store the machine or accessories in a place where the temperature could drop below
40°F.
AFTER EXTENDED STORAGE
Scale deposits may form in the pump when it is not used for some time. This causes the motor to
hesitate or not start up at all.
1. Do not plug the unit into electrical outlet or connect the pressure hose to the unit.
2. Connect garden hose to the unit and allow the water to exit from pressure outlet for a few
seconds to rinse the system.
3. Shut off the water.
4. Connect pressure hose to the gun and pressure washer.

MAINTENANCE

18