AllTrade TRADES PRO 830271 Manual De Instrucciones página 20

CONNECTIONS
Connections (fittings) on Pressure Washer, pressure hose, gun and spray wand should be
cleaned regularly and lubricated with non-water soluble grease to prevent leakage and damage
to the o-rings.
NOZZLE
The nozzles should be lubricated with non-water soluble grease or light oil regularly. Clogging
of the nozzle causes the pump pressure to build up too high and cleaning is required.
1. Make sure Pressure Washer On/Off switch is set to
Off and spray gun trigger is locked.
2. Set the nozzle to high pressure setting to make the
nozzle hole accessible.
3. Clear blockage in nozzle by inserting the nozzle
cleaning needle (provided) through center hole.
4. After cleaning, remove the needle from nozzle and
store for future use.
WATER INLET FILTER
The Pressure Washer is equipped with a water inlet filter to protect the pump from foreign
debris.
1. Remove the garden hose coupling from pressure washer water inlet and then gently remove
the rubber gasket over the screen filter and remove the filter from inside the inlet.
2 . CAREFULLY clean the filter by using a nonabrasive and dull object (finger or soft brush).
Make sure screen is not torn or broken.
3. Reinstall the filter, rubber gasket and coupling. FIRMLY hand tighten the coupling to prevent
water leakage.
FILTER
19
COUPLING
GASKET