Publicidad
Idiomas disponibles
Idiomas disponibles
CONTINUOUS STEAM
EN
CONTINUOUS STEAM
STEAM BOOST
On NYLON mode, the steam is blocked in order to protect your clothes.
On linen and cotton mode only, to eradicate the toughest creases, you can activate the steam
boost: press the trigger to the max level (1 seconde max) and release (
a few seconds between each shot before pressing the trigger again.
STEAM BOOST
IMPORTANT Leave an interval of a few seconds between each shot and wait until the
flow of steam has finished before standing the iron on its heel.
5 • Vertical shot of steam
Select the Linen mode and hold the iron vertically. Press the trigger to the max level to activate
the shot of steam to remove creases from suits, jackets, skirts, hanging curtains etc.
a few seconds between each shot before pressing the trigger again.
IMPORTANT Never direct the steam at persons or animals!
TIP Hold the iron 20 centimetres away from the garment to avoid burning delicate
fabrics.
fig 7-b or
below). Wait
fig 8
6
6 • Anti-Drip system
It prevents water dripping out of the soleplate when the temperature is too low.
7 • Auto Off function
• For your safety, the electronic system cuts off the power and the auto off indicator
light flashes
fig 9
when:
- The iron remains motionless for more than 8 minutes on its base
- The iron remains flat or on its side for more than 30 seconds
To restart the iron, just move it gently until the warning light stops flashing.
AFTER USE
8 • Emptying
Unplug the iron
fig 1
. Pour away remaining water
9 • Storing
Allow the appliance to cool down for 1 hour before winding the cord around the heel. Store
the iron on its base in a dry and safe place
IMPORTANT Do not wind the cord around the hot soleplate. Never store your iron
placed down on the soleplate.
MAINTENANCE AND CLEANING
Remove the plug from the wall socket and let the iron cool down before
maintenance and cleaning.
10 • Cleaning the iron
When the appliance has cooled down, wipe the iron down with a damp cloth or sponge. A non
abrasive cleaning agent can be used.
IMPORTANT Do not use sharp or abrasive cleaning agents or objects to clean the
soleplate and other parts of the iron.
WARNING : Do not use descaling agents even if advertised for steam irons. They will
permanently damage your iron.
11 • Calc clean program (4-6 min)
The Calc Clean System flushes dirt and scale particles out of the steam chamber.
. Wait
This considerably prolongs the operational life of your iron.
Your iron needs to be cleaned when the CALC CLEAN warning light remains lighted on the
LED screen
fig 11a
.
If the "CALC CLEAN" light starts flashing when you are ironing, you can finish your ironing
session. There is no risk for your clothes nor the appliance.
fig 10
.
fig 12
.
7
EN
Publicidad
