Publicidad
Idiomas disponibles
Idiomas disponibles
The threaded holes face inward
and are located at the backside.
NOTE: Please do not fully tighten all bolts until you finish assembling all parts. Once assembled, go back
and fully tighten all bolts. This will make the assembly easier.
1. Unpack the unit and confirm that you have all the hardware and required parts. Assemble the unit on a
carpeted floor or the empty carton to avoid any scratch.
2. Ask for assistance to place the Desk Top (A) upside down.
3. Orient and attach the Left Side Frame (B) to the Desk Top (A) with three 30 mm Bolts (2), three Lock
Washers (3) and three Flat Washers (4). DO NOT fully tighten the bolts in this step.
4. Attach the Bottom Back Stretcher (D) to the Left Side Frame (B) using two 15 mm Bolts (1), two Lock
Washers (3) and two Flat Washers (4).
Assembly Instructions
B
A
D
B
4
Publicidad
