Descargar Imprimir esta página

MSW -WIRESTRIPPER-Y3 Manual De Instrucciones página 20

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 60
i)
If the machine does not cut the insulation from the cable, there are several possible causes:
a.
Cable diameter too small.
b. The center of the blade is not aligned with the center of the groove (adjust the blade core).
c.
The edge of the blade is too dull (sharpen it).
j)
When finished working, turn off the device.
3.5.
Cleaning and maintenance
a)
Pull the mains plug and let the unit cool down completely before cleaning, adjusting or replacing
accessories and when the unit is not in use.
Wait until the rotating parts stop.
b)
Use only non-corrosive cleaning agents for cleaning the surfaces.
c)
Store the unit in a dry and cool place protected from moisture and direct sunlight.
d)
Do not spray the unit with a stream of water or immerse it in water.
e)
Make sure that no water enters through the ventilation openings in the casing.
f)
Clean the ventilation openings with a brush and compressed air.
g)
Perform regular inspections of the unit checking technical fitness and any damages.
h)
Use a soft cloth for cleaning.
i)
Do not use sharp and/or metal objects (e.g. wire brush or metal spatula) as they may damage the surface
of the material from which the appliance is made.
j)
Do not clean the unit with acidic substances, medical agents, thinners, fuel, oils, or other chemicals. It
may cause damage to the device.
k)
For long-term storage, protect the cutting rollers and casters with oil.

Publicidad

loading