Publicidad
Idiomas disponibles
Idiomas disponibles
Prepare the Hood
1 ] If present, remove all protective polyfilm from the hood and/or parts.
2 ] Using the tab, remove the grease filters from the hood by pushing down and tilting filters out.
3 ] Remove both screws holding damper assembly to hood. Remove parts bag included with
the hood (captured behind the damper assembly).Remove damper assembly from inside the
hood and keep the screws for further use.
NOTE: Remove the EZ1 brackets from inside the hood by cutting off the tie wrap.
EZ1
BRACKETS
4 ] Remove the wiring cover (shaded part on illustration below) by sliding it out from the hood
and set it aside.
SCR EWS
DAMPER
ASSEMBLY
9
Publicidad
