VBM REPLICA HX Manual De Instrucciones página 46

•
If case of machine malfunctioning or damage to the components, contact your local dealer or the
manufacturer.
•
THESE SAFETY STANDARDS INTEGRATE OR BALANCE THE LOCAL SAFETY REGULATIONS IN FORCE.
•
IN CASE OF DOUBT, ALW AYS REQUEST THE INTERVENTION OF SPECIALISED PERSONS.
•
ANY ELECTRICAL/ELECTRONIC OR MECHANICAL TAMPERING WITH THE MACHINE BY THE USER
AND NEGLIGENT USE OF THE MACHINE RELIEVES THE MANUFACTURER OF ALL RESPONSIBILITY
AND MAKES THE USER SOLELY RESPONSIBLE TOW ARDS THE COMPETENT BODIES FOR THE
PREVENTION OF ACCIDENTS.
IT IS PROHIBITED TO:
•
Operate the machine without observing the safety rules in force in the country of installation.
•
Operate the machine if it is not connected to ground. Inobservance of this instruction may give rise to
electric shock.
•
Replace or remove the safety decals and the data plate affixed directly on the machine and on the packaging
for proper and safe installation and use.
•
Touch the units or spouts during machine operation. The nozzles must be handled only by the grips. The
drinks dispensed and/or some parts of the machine are hot and can cause burns.
•
Remove or tamper with any part of the machine and make arbitrary modifications. If necessary, contact an
authorised and specialised area technician.
•
Pull the power cable to disconnect the plug.
•
Use adaptors, multiple sockets and/or extensions.
•
Use the machine if the power cable is frayed or damaged.
•
Let children or unqualified persons use the machine.
•
Expose the machine to atmospheric agents (sun, rain etc.).
•
Leave the machine in places where the ambient temperature is equal to or below 0°C, as the residual water
in the boiler could freeze and cause damage.
•
Install the machine in places where water jets that could reach the machine are used.
•
Operate the machine if all the doors or panels are not properly closed.
•
Insert spoons, forks or other utensils into the inner parts of the machine.
•
Operate the machine without water.
•
Obstruct the vents; leave at least 10cm of space between the machine and any walls and at least 5cm on
either side to allow proper ventilation.
6