Publicidad
INTRODUCTION
Thank you for the purchase of our quality product. Used carefully and in accordance with the instructions set
out below. Please read and keep these instructions for future reference..
FEATURES
- Power: 3500W /16A.
- Voltage: 220-240V
- Hz: 50Hz
- Working temperature: -10ºC + 50ºC
- Reservation time: 100h.
- Working time: 15 mín. - máx. 24h.
- Precision: +- 3 seg/día.
- Dial tipy: 96 pins.
- IP: IP20.
Attention: electrical devices must be installed by
authorized personnel. It should be installed in a
35mm symmetrical distribution board in accor-
dance with EN 50 022.
Very important:
The switch is internally protected against interfe-
rence by a security device. However, high electro-
magnetic fields could alter its operation.
Such interference can be avoided by following
these instructions:
1. The device must not be installed near inductive
loads (motors, transformers, conductors, etc.).
2. A separate line for power (equipped with a ne-
twork filter if necessary).
3. Inductive loads should be equipped with inter-
ference suppressors (RC filters).
If the timer is to be used in combination with other
devices, it is necessary to check that there are no
disturbances caused by the whole group.
4. Connection in regime.
Manual mode
Índex
PROGRAMMING
Move all the pins to the right, move to the left the
pins corresponding to the desired connection time in
which contact 1 - 2 is closed.
Time update:
Rotate the dial until the index is at the current time.
Manual mode:
It has two positions:
= Automatic operation
I = Permanent connection.
L
N Linea
Dial programming
Dial
Puente
L1
Retorno
bombilla
N Bombilla
www.garsaco.com | 3
EN
Publicidad
